Select Page

Controls for Phantom and Orbiter

DC Motor Control

Part Number: 121161

DC Motor Control—Since Orbiter and Phantom have DC motors, this control unit is required for IR or RF remote control, or when interfacing with a master control system.

Lift L.V. Control Station

Part Number: 121246

The Lift L.V. Control Station (wall switch/dry contact) is a 3 position (UP, Stop, Down) switch mounted on white single gang panel that is used to control the Lift L.V. (Lift Low Voltage Control Module). 110 V

Lift IRT/R

Part Number: 121251

The IRT/R is an Infrared (IR) transmitter and receiver. 3-button operation. Fully compatible with “learn-able” IR master control systems. Receiver plugs into the Lift LV Control or DC Motor Control. 110 V

Lift WRT

Part Number: 121250

Infrared transmitter (IRT). Must be used with receiver and low voltage control module. 110 V

Lift WRT

Part Number: 121248

Hand-held radio frequency transmitter (WRT). 3-button control lets you stop or change direction at any point. Requires receiver and Draper low voltage control unit. 110 V

Lift WRT/R

Part Number: 121249

Hand-held radio frequency transmitter (WRT). 3-button control lets you stop or change direction at any point. Requires The WRT/R is a hand-held RF transmitter/receiver. 3-button control. The RF receiver plugs into the Lift LV Control, DC Motor Control.receiver and Draper low voltage control unit. 110 V

R2D7 for RS232 Serial Control

Part Number: C156.066

The serial bridge allows third party control of our low voltage control via serial RS-232 ASCII commands.

Serial Port Adapter (9 pin to RJ11)

Part Number: C103.042

Converts a standard DB9 serial output of a PC into an RJ11 connection providing RS232 serial commands.

Obstruction Shut-Off Control Kit

Part Number: 300214