Select Page

Controls for Scissor Lift SL

Lift LV Control Station

Part Number: 121246

The Lift L.V. Control Station (wall switch/dry contact) is a 3 position (UP, Stop, Down) switch mounted on white single gang panel that is used to control the Lift L.V. (Lift Low Voltage Control Module). 110 V

R2D7 for RS232 Serial Control

Part Number: C156.066

The serial bridge allows third party control of our low voltage control via serial RS-232 ASCII commands.

Serial Port Adapter (9 pin to RF11)

Part Number: C103.042

Converts a standard DB9 serial output of a PC into an RJ11 connection providing RS232 serial commands.

Lift WRT/R

Part Number: 121249

Hand-held radio frequency transmitter (WRT). 3-button control lets you stop or change direction at any point. Requires The WRT/R is a hand-held RF transmitter/receiver. 3-button control. The RF receiver plugs into the Lift LV Control, DC Motor Control.receiver and Draper low voltage control unit. 110 V

Lift L.V. Control Station 220V

Part Number: 121247

The Low Voltage Control Station is a 3-button control switch for use with the Lift LV Control. It features three buttons for “up”, “stop” and “down” control. 220V 220 V

SP-KSM

Part Number: 121022

Need a keyed switch for security? The SP-KSM replaces the standard 3-position key switch (KS-3) where a spring-loaded action is required. It combines the directional functions (Up and Down) with the security of a key switch. Use for low voltage contact closure or multiple switching. This switch is necessary to access the service position of the scissor lifts.

Lift WRT

Part Number: 121248

Hand-held radio frequency transmitter (WRT). 3-button control lets you stop or change direction at any point. Requires receiver and Draper low voltage control unit. 110 V

VIC-12 Cideo Interface Control

Part Number: 121024

Allows screen to be controlled by projector switch–when the projector comes on, the screen descends automatically. The VIC-12 interfaces screen operation with a video projector or tuner featuring a 12V switched outlet.

The VIC-12 can be purchased with an override switch (VIC-OS), permitting independent operation. A VIC is not compatible with a Lift LV Control, built-in or otherwise. 110 V

Lift IRT/R

Part Number: 121251

The IRT/R is an Infrared (IR) transmitter and receiver. 3-button operation. Fully compatible with “learn-able” IR master control systems. Receiver plugs into the Lift LV Control or DC Motor Control. 110 V

Lift IRT

Part Number: 121250

Infrared transmitter (IRT). Must be used with receiver and low voltage control module. 110 V

KS-1

Part Number: 121017

Useful with any control system for a Draper electrically operated projection screen, the KS-1 power supply switch mounts next to the operating switch and controls power to it. Single-Pole, Single-Throw (On-Off). Maintained action. Low voltage or 115V. 110 V

SP-KSM

Part Number: 121022

Need a keyed switch for security? The SP-KSM replaces the standard 3-position key switch (KS-3) where a spring-loaded action is required. It combines the directional functions (Up and Down) with the security of a key switch. Use for low voltage contact closure or multiple switching. This switch is necessary to access the service position of the scissor lifts. 110 V